That’s where the becomes your best friend. You don’t need expensive third-party software to verify your toolpath. You need to learn how to use the "symulator" (simulator) already inside the control.
Before simulating, go to Program Run / Full Sequence mode. Press the GRAPHICS soft key (usually the middle of the bottom row). Then press BLANK FORM . Define your raw stock (X, Y, Z dimensions) exactly as it sits on your table. If you skip this, the simulator doesn't know what to cut. symulator itnc 530
Do you use the iTNC 530? What is the worst crash you caught using the simulator? Let me know in the comments below. That’s where the becomes your best friend